|
|
|
Xedit Corporation
Short ceiling dress bezel with internal switch for ball microphone. This small, nicely turned component provides a finished opening in the ceiling for the Ball microphone and cable.
Model: BZ-1
Microphones »
Related Microphone Products
|
|
|
|
|
Xedit Corporation
Long ceiling dress bezel with internal switch for Shure MX202 microphone. This small, nicely turned component provides a finished opening in the ceiling for the microphone and cable.
Model: BZ-2
Microphones »
Related Microphone Products
|
|
|
|
|
Xedit Corporation
Ceiling dress bezel with internal switch for polycom-HDX microphone. This small, nicely turned component provides a finished opening in the ceiling for the Polycom-HDX microphone and cable.
Model: BZ-3
Microphones »
Related Microphone Products
|
|
|
|
|
|
|
|
Xedit Corporation
The CP-1 Cable clamp is designed to provide a good mechanical linkage between the 2mm microphone cable and some type of microphone-bar payload; without causing a permanent imprint on the thin cable jacket.
Model: CP-1
Microphones »
Related Microphone Products
|
|
|
|
|
|
|
|
Xedit Corporation
Motorized microphone positioner/reeler, uses monofilament line to horizontally position suspended microphones. Designed to pull and feed a fine monofilament line by remote control.
Model: MPS-2
Microphones »
Related Microphone Products
|
|
|
|
|
Xedit Corporation
MX202 is needed to hang pointing straight down, it can be an advantage to remove the 4.5-inch flexible shaft. The remaining microphone head is quite small approaching the desirable size of our Ball microphone, but employing a Cardioid capsule.
Model: MX202
Microphones »
Related Microphone Products
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Xedit Corporation
The modification allows the MX202 to hang straight down. The flexible tail section is removed and replaced with a painted brass cap. The resulting smaller microphone fits into our standard bezel assembly so it will retract flush with the ceiling surface.
Model: RM-1 MOD
Microphones »
Related Microphone Products
|
|
|
|
|
Xedit Corporation
The RM-2 microphone consist of a high performance condenser capsule embedded into a machined stainless steel or brass ball. The ball provides good acoustic mass and a little ballast which exerts adequate pull on the microphone cable.
Model: RM-2
Microphones »
Special Application Microphones
|
|
|
|
|
Xedit Corporation
Suspended ceiling bridge novel bridge assembly makes Servoreeler installation over a suspended ceiling much fasterĀ - significantly reducing labor time and installation costs.
Model: SCB-24
AV Lifts »
Related Lift Products
|
|
|
|
|
|
|
|
|
|
|
Xedit Corporation
The SRCC-1 Control board is employed by all SRC controllers. It can also be used to assemble controllers for systems employing virtually any number of microphone Servoreelers.
Model: SRCC-1
Control Systems »
Related Control Systems Products
|
|
|
|
|
|
|
|